Filter
Top Products
10
Using the plug-on transmitter
Using the plug-on transmitter
To establish a transmission link, proceed as follows:
1. Switch the receiver on (see the instruction manual of the receiver).
2. Switch the plug-on transmitter on (see next section).
The transmission link is established and the diversity receiver’s RF level
display “RF” reacts.
If you cannot establish a transmission link between plug-on transmitter
and receiver, read the chapter “Synchronizing the plug-on transmitter
with a receiver” on page 26.
Switching the plug-on transmitter on/off
To switch the plug-on transmitter on (online operation):
To switch the plug-on transmitter on and to deactivate the RF signal on
switch-on (offline operation):
It is vital to observe the notes on frequency selection on page 26.
̈ Press the ON/OFF button º.
The plug-on transmitter transmits an RF signal. The red
ON LED ¶ lights up and the “Frequency/Name” standard
display appears on the display panel. The transmission icon ብ
is displayed.
̈ Keep the ON/OFF button º pressed until “RF Mute On?”
appears on the display panel.
¶
º
ON/OFF
ON/OFF