Sennheiser SK 100 Satellite Radio User Manual


 
26
Synchronizing the bodypack transmitter with a receiver
Synchronizing the bodypack
transmitter with a receiver
When synchronizing the bodypack transmitter with a
receiver, please observe the following:
Synchronizing the bodypack transmitter
with the receiver – individual operation
Upon delivery, the bodypack transmitter and the receiver
are synchronized with each other.
If, however, you cannot establish a transmission link
between bodypack transmitter and receiver, you have to
synchronize the channels of the devices.
For information on automatic synchronization of the body-
pack transmitter with the receiver (individual operation),
refer to the instruction manual of the receiver. This infor-
mation is marked with the icon.
Alternatively, you can set the channel on the bodypack
transmitter manually:
̈ Make sure that you set the bodypack transmitter to the
same frequency bank and the same channel as the
receiver (see page 21).
If you still cannot establish a transmission link, refer to the
chapter “If a problem occurs ...” on page 29.
Synchronizing bodypack transmitters with
receivers – multi-channel operation
Combined with ew 100 G3 receivers, ew 100 G3 bodypack
transmitters can form transmission links that can be used
in multi-channel systems.
For information on automatic synchronization of bodypack
transmitters with receivers (multi-channel operation), refer
to the instruction manual of your receiver.
For more information on multi-channel operation, visit the
SK 100 G3 product page at www.sennheiser.com.
̈ Only use a transmitter and a receiver from the
same frequency range (see the type plate on the
transmitter and the receiver).
̈ Make sure that the desired frequencies are listed
in the enclosed frequency information sheet.
̈ Make sure that the desired frequencies are
approved and legal in your country and, if neces-
sary, apply for an operating license.