Filter
Top Products
28
Recommendations and tips
Recommendations and tips
... for the ME 2 and ME 4 clip-on microphones
• To reduce level variations to a minimum when the user
turns his or her head away from the microphone,
attach the microphone as centrally as possible.
• To protect the microphone against excessive sweat/
moisture, avoid direct skin contact.
• Attach the microphone carefully and conduct the cable
so that noise due to friction is avoided.
• Always use the ME 4 directional microphone with a
windshield and direct the microphone towards the
sound source (e.g. mouth).
... for the ME 3 headmic
• Always use the microphone with a pop shield and posi-
tion the microphone at the corner of the mouth.
• You can vary the bass reproduction by increasing/
decreasing the talking distance.
• Make sure that the sound inlet is directed towards the
mouth. The sound inlet is marked with a little dot.
... for the bodypack transmitter
• Make sure that the antenna and the microphone cable
do not cross.
• The antenna should hang freely and be at least 1 cm
away from the body. The antenna must not be in direct
contact with the skin.
• For best results, make sure that the transmitter sensi-
tivity is correctly adjusted.
... for optimum reception
• Transmission range depends to a large extent on loca-
tion and can vary from about 10 m to about 150 m.
There should be a “free line of sight” between trans-
mitting and receiving antennas.
• To avoid overloading the receiver, observe a minimum
distance of 5 m between transmitting and receiving
antennas.
... for multi-channel operation
• For multi-channel operation, you should only use the
channels within one frequency bank. Each of the
frequency banks “1” to “20” accommodates factory-
preset frequencies which are intermodulation-free.
• When using several transmitters simultaneously, inter-
ference can be avoided by maintaining a minimum
distance of 20 cm between two transmitters.