Filter
Top Products
25
Adjusting settings via the operating menu
The bodypack transmitter adds an inaudible signal, known
as the pilot tone, to the transmitted signal. The receiver
detects and evaluates the pilot tone.
The pilot tone supports the receiver’s squelch function
(Squelch) and protects against interference due to
RF signals from other devices.
Devices of the ew 100 G1 series (generation 1) do not
support the pilot tone function. Therefore, please observe
the following when combining a bodypack transmitter or
receiver of the ew 100 G3 series (generation 3) with
devices from an earlier evolution wireless generation:
Adjusting the contrast of the display panel –
“LCD Contrast“
You can adjust the contrast of the display panel in 16 steps.
Resetting the settings made in the operating menu –
“Reset”
When resetting the settings made in the operating menu,
only the selected settings for the pilot tone and for the
frequency bank “U” remain unchanged. For an overview of
the factory-preset default settings, refer to the supplied
frequency information sheet.
Displaying the software revision – “Software Revision”
You can display the current software revision of the body-
pack transmitter.
Transmitter Receiver Make sure to ...
w G3/ w G2 w G3/ w G2 ... activate the pilot
tone function on both
bodypack transmitter
and receiver.
w G3 w G1 ... deactivate the pilot
tone function on the
ew 100 G3 bodypack
transmitter.
w G1 w G3 ... deactivate the pilot
tone function on the
ew 100 G3 receiver.
Advanced
Menu
Reset
Yes
Reset
“Stored”
SET
SET
Select the desired
setting; apply the
setting
Call up “Reset”