Filter
Top Products
24
Cleaning the Set 830 S-MKE
Cleaning the Set 830 S-MKE
Cleaning the transmitter and the receiver
̈ Before cleaning, disconnect the transmitter from the
mains.
̈ Use only a slightly damp cloth to clean the devices.
If a problem occurs ...
The transmitter does not switch on
Liquids can damage the electronics of the
devices!
Liquids entering the housing of the devices
can cause a short-circuit and damage the
electronics.
̈ Keep all liquids far away from the devices.
̈ Do not use any cleansing agents or
solvents.
Possible cause Solution
Is the mains unit
connected correctly?
Check the connection of the mains
unit to the transmitter and to the
mains (see page 10).
Is the sound source
switched on?
Switch your sound source on.
Is the volume of
the sound source
sufficient?
Set the volume on your sound
source to a medium level.
Is the transmitter
set to operating
mode 2 (see
page 29)?
Take the receiver out of the
charging compartment. The trans-
mitter automatically switches on.
CAUTION!