Sennheiser HDR180 Headphones User Manual


 
21
Using the RS 180
Switching the headphones on and off
Switching the headphones on
̈ Press the multi-function button ² for approx. 1 second.
The headphones switch on. The multi-function LED µ flashes green,
indicating that the headphones are in enrollment mode.
Once the headphones have found a suitable transmitter, the
transmitter pairs with the headphones and transmits an audio signal.
The multi-function LED µ of the headphones and the multi-function
button of the transmitter flash slowly.
Switching the headphones off
̈ Press the multi-function button ² for approx. 1 second.
The multi-function LED µ goes off. The headphones are in standby
mode.
WARNING Danger due to high volumes!
Listening at high volume levels for long periods can lead to
permanent hearing defects.
̈ Before putting the headphones on, set the volume to a low
level.
̈ Do not continuously expose yourself to high volumes.
1s
5s
If there is no signal from the transmitter for more than 5 minutes,
the headphones automatically switch to standby mode.
3
µ