Sennheiser EM 2000 Stereo Receiver User Manual


 
Using the receiver
14
Using the receiver
To establish a transmission link, proceed as follows:
1. Switch the receiver on (see next section).
2. Switch the transmitter on (see the instruction manual of the transmitter).
The transmission link is established and the display backlighting of the receiver changes
from red to orange.
If you cannot establish a transmission link between transmitter and receiver, read the
chapter “Synchronizing transmitters with receivers” on page 31.
Switching the receiver on/off
To switch the receiver on:
To switch the receiver to standby mode:
To completely switch the receiver off:
̈ If necessary, deactivate the lock mode (see page 15).
̈ Disconnect the receiver from the mains by unplugging the mains cable plug from the wall
socket.
The backlighting of the STANDBY button º goes off.
Monitoring the audio signal via headphones
̈ Set the headphone volume control » to the minimum position.
̈ Connect headphones with a ¼” (6.3 mm) stereo jack plug to the headphone output ·.
̈ Gradually increase the volume and monitor the audio signal with the lowest possible
volume.
It is vital to observe the notes on frequency selection on page 31.
.
200
U
TE
MHz
**2000**
SKM2000
º
̈ Briefly press the STANDBY button º.
The receiver switches on and the “Receiver Parameters” standard display
appears.
̈ Keep the STANDBY button º pressed until “OFF” appears on the display panel.
The receiver switches to standby mode. The integrated antenna splitter and the
booster supply voltage remain active so that the antenna signals are still looped
through to daisy-chained receivers.
When in the operating menu, pressing the STANDBY button º will cancel your
entry (ESC function) and return you to the current standard display.
•The STANDBY button º is backlit in red both during operation and in standby
mode.
CAUTION! Danger of hearing damage!
Listening at high volume levels for long periods can lead to permanent hearing defects.
̈ Set the headphone volume control » to the minimum position before putting the head-
phones on.
B.Ch:
PEAK
EQ:
+ 1
P
-10
0
40
30
20
10
-20
-30
-40
AF
RF
True Diversity Receiver EM 2000
·
»