Filter
Top Products
Using the devices
17
To completely switch the transmitter off:
̈ Disconnect the transmitter from the mains by unplugging the mains unit from the wall
socket. The backlighting of the STANDBY button ¶ goes off.
Switching the EK 300 IEM G3 diversity receiver on/off
To switch the diversity receiver on:
̈ Turn the volume control ³ clockwise until it clicks.
The red ON LED ¿ lights up. The “Frequency/Name” standard display appears on the
display panel.
To switch the diversity receiver off:
̈ Turn the volume control ³ counterclockwise until it clicks.
The red ON LED ¿ goes off and the diversity receiver switches off.
Monitoring the audio signal via headphones
To monitor the audio signal via the headphone output of the diversity receiver:
̈ Connect earphones with a 3.5 mm stereo jack plug to the headphone output ·.
̈ When switching the receiver on, slowly and carefully turn the volume control ³ clockwise.
̈ Via the receiver’s operating menu (see page 24), adjust:
– stereo or Focus operation (“Mode” menu item)
– the balance (“Balance” menu item)
– the treble boost (“High Boost” menu item)
–the limiter (“Limiter” menu item)
To monitor the audio signal via the headphone output of the transmitter:
̈ Set the headphone volume control · to the minimum position.
̈ Connect headphones with a ¼” (6.3 mm) stereo jack plug to the headphone output ³.
̈ Gradually increase the volume and monitor the audio signal with the lowest possible
volume.
When in the operating menu, pressing the STANDBY button ¶ will cancel your
entry (ESC function) and return you to the standard display.
The STANDBY button
¶ is backlit in red both during operation and in standby
mode.
ᕤ
ᕡ
CAUTION! Danger of hearing damage!
Listening at high volume levels for long periods can lead to permanent hearing defects.
̈ Set the volume control to the minimum position before putting the headphones on.
̈ Do not continuously expose yourself to high volumes.
ᕡ·
The ground connection of the earphones cable serves as the second antenna for
adaptive diversity operation.
Stereo Transmitter
³ ·