Filter
Top Products
2.6 KARAOKE SETUP
2.6.1 MIC SETUP
2.6.1.1 MIC
Set this item to ON/OFF to switch on/off the connected microphone(s).
2.6.1.2 MIC VOL
Enter this item, then use direction key [ ]/[ ] to adjust the microphone volume. Then
press [ENTER] to confirm your adjustment.
2.6.1.3 ECHO LEVEL
Enter this item, then use direction key [ ]/[ ] to adjust the microphone echo level. Then
press [ENTER] to confirm your adjustment.
-15-
3 DOLBY DIGITAL SETUP
3.1 DUAL MONO
STEREO: The player outputs the left-channel audio and right-channel audio via the FL
and FR speaker respectively.
L-MONO: The player outputs the left-channel audio only via both the FL and FR speaker.
R- MONO: The player outputs the right-channel audio only via both the FL and FR
speaker.
MIX- MONO: The player outputs the average signal of the left-channel and right-channel
audio via the FL speaker and the FR speaker.
NOTE: This function only applies to the Dolby AC -3 encoded 2-channel discs.
3.2 DYNAMIC
When you watch films with large dynamic scope in low volume, for example at night, you
can adjust the dynamic value up to avoid losing sound details resulting from the low
volume.
4. 2 RESOLUTION
Select a resolution in this setting item.
4.3 COLOR SETTING
4.3.1 SHARPNESS
There are three options (HIGH, MEDIUM and LOW) for you to choose in this item.
4.3.2 BRIGHTNESS, CONTRAST, HUE and SATURATION
Enter these items respectively, use direction key [ ]/[ ] to adjust the value, then press
[ENTER] to confirm it.
4.3.3 GAMMA
There are four options (HIGH, MEDIUM, LOW and NONE) for you to choose in this item.
4 VIDEO SETUP PAGE
4.1 VIDEO OUTPUT
OFF: Set video output to the composite output.
YUV: Set video output in analog component video format if the component video outputs
are used.
RGB: Set video output in Red/Green/Blue format if the SCART output is used.
NOTE: If the video setting differs from the actual video connection, you may get no
image or very poor image on the TV. In such case, you need to reset this setting item for
an appropriate video output mode or press [V-MODE] until the output image becomes
normal.
System Setup