Samson C com 16 Stereo System User Manual


 
ENGLISH
18
Tilting and Stacking the C com 16
Installing the Tilting Feet
You can install the tilting rubber feet included with
your C com 16 so that you can set the unit at a com-
fortable operating angle on a workstation or desktop.
Follow the simple instructions below to install the tilt-
ing feet.
Remove the bottom screw from right front
bumper.
Identify the right tilting foot by the locating “R”
marking on the inside top.
Position the angled foot under the right bum-
per as shown in the drawing.
Use the included 4 x 10mm screw to attach the
foot.
Repeat the steps above for the front left bum-
per.
Stacking the C com 16
You can stack one C com 16, or any other Samson C Class units, on top of each other by simply lining up the
bumpers.
Important Note: When stacking the C COM 16, be sure that only the bottom unit has the tilting feet installed.