Russound MCA-C5 Stereo Amplifier User Manual


 
19
Russound MCA-C5 User and Installation Manual
Source Audio Connections
On the MCA-C5, sources 1 through 8 have standard stereo audio inputs and
loop outputs. All source inputs have audio signal sensing. These sources can
be programmed during zone setup to be global sources, or zones can be
individually programmed to restrict access to sources.
There is an internal AM/FM tuner that, if enabled, will occupy source 1. The
tuner is enabled with the SCS-C5 software. If utilizing the internal tuner, do not
connect/congure another source on source 1.
Connect each source output using quality RCA signal cables. Connect the Left
and Right Audio outputs from each source to the corresponding inputs on the
MCA-C5 controller.
The buered loop-through outputs are used to loop to additional controllers
or other AV switching systems (e.g., home theater receiver).
SOURCE CONNECTIONS
RNET Source Data Connections
The RNET Link In and Link Out can be used to connect the MCA-C5 to other
specied Russound RNET-enabled source equipment. The connection is made
using a CAT-5e patch cable from the Link Out of the controller and into the Link
In of the RNET-enabled source. Another CAT-5e patch cable can be used to link
out of that source and link into another RNET-enabled source in the system.
Use a standard CAT-5e patch cable with an RJ-45 connector on each end.
Along with RNET data signals, the RNET Link In and Link Out port passes
source IR signals. To avoid potential cross-talk between the source-specic IR
repeating signal lines, the cable can not exceed 18 inches in length.
ST2 Tuner
RS-232
INTERFACE
12VDC 1.25A
I
N OUT
NEWMARKET, NH U.S.A.
ST2
Smart Tu ner
LINK KEYPAD PORTS
Serial#
MADE IN KOREA
TUNER 1
FM COAX
LOOP
ANTENNA
IR
LR
A
UDIO OUTPUT
IR
LR
A
UDIO OUTPUT
TUNER 2
FM COAX
LOOP
ANTENNA
MCA-C5 Controller
CAT-5e Cable
RNET Source Connection to MCA-C5
RCA cable
CD Changer
MCA-C5 Controller
Audio Source Connection to MCA-C5