Filter
Top Products
INSTALLER
INSTALLATION MENU
i. MACRO - Macro loads a series of commands which are processed when
(Macro) activated.
ii. MACRO ID – Enter the macro ID number. Menu advances to SAVE CHANGES
(MacID) (step 9)
e. All Other Selections: Procedure advances to DEVICE CODE (step 7)
7. DEVICE CODE – Enter source component code number listed in this manual’s
(DevCd) Reference section.
8. KEY FUNCTION – Select a function for the button.
(KeyFn)
9. SAVE CHANGES? – Select “yes” to save changes. Procedure advances to ZONE NUM
(Save?) (step 1)
SOURCE NAMES (Sr
cNm)
This procedure allows the installer to customize the source names for the sources attached to the
CAM6.6.
See Source Names/Vol Trim - Flow Chart on page 67
1. SOURCE NUM – Select the source number this name will be assigned to.
(Src #)
2. SOURCE NAME – Select the name. SOURCE NUM will reappear on the LCD panel;
(Name) repeat the instructions for each source to be labeled.
SRC VOL TRIM (SrcVT)
This procedure allows the installer to adjust the output level of an individual source. The output vol-
ume is adjustable by 16dB. At 0dB (-3dB is the default setting), the volume is at max output; at -16dB
the volume is at the lowest setting possible for that source only.
See Source Names/Vol Trim -
Flow Chart on page 67
1. SOURCE NUM – Select the source number this level will be set for.
(Src #)
2. TRIM LEVEL – 0dB is max output volume, -16dB is lowest setting.
(Trim)
NUMERIC IR (NumIR)
Numeric IR allows the installer to program source specific number functions (Channel 12, Disk 89, etc.).
See Numeric IR - Flow Chart on page 68
53