Filter
Top Products
16
USER
INTERNAL SOURCE - AM/FM TUNER
UNO-S2 Keypad Control
UNO-S2 Keypad Contr
ol of Tuner
Selecting the tuner
On the UNO-S2 keypad, press to select the
AM/FM tuner by choosing the tuner’s preas-
signed source number (1).
Selecting the desired band
Push to toggle between AM band and FM
band reception.
Selecting the desired frequency
Use and for manual tuning. The fre-
quency will appear on the keypad and the active
tuner. To move quickly through the stations,
press and hold either or for more than
1.5 seconds
.
Frequency Seek
A press on will seek the next higher tune-
able station. If a tuneable station is not found,
end the SEEK function by pressing again.
Frequency Scan
To scan, press and hold then release . The
tuner scans through tuned stations with a 5-sec-
ond preview before moving to the next station.
To end scanning, press again.
Selecting a Bank
The AM/FM tuner can store up to 36 favorites,
or memory presets. These are stored in groups
of six called banks, and there are six banks.
Each preset and each bank can be given a cus-
tom name of your choice.
To select a bank, press and hold for bank
up or for bank down. The bank’s name will
be temporarily displayed on the UNO-S2. Banks
and memory presets are custom-named in the
Peripheral Setup Menu (see Installation Menu
section of this manual).
Recalling a Memory Preset
Press and to scroll through the memo-
ry presets for the selected bank. This procedure
will step through all of the presets in the current
bank, then loop back to start at the first one.
Only configured presets will be displayed.
Mute
Press to mute/unmute the tuner audio output.