Filter
Top Products
18
USER
INTERNAL SOURCE - AM/FM TUNER
UNO-LRC1 Remote Control
UNO-LRC1 Contr
ol of Tuner
Selecting the tuner
To select the tuner, push and choose the
source number preassigned to the AM/FM tuner (1),
or use the UNO numeric source inputs at the bottom
of the UNO-LRC1.
Selecting the desired band
Push to toggle between AM/FM reception.
Selecting the desired frequency
Use the Channel and or and
for manual tuning. To move quickly through the
channels, press and hold the button for more than
1.5 seconds. To directly select a station, enter the
three- or four-digit channel or frequency (1071 for
107.1, etc.). European regions use five-digit station
frequencies.
Frequency Seek
The SEEK function is performed by pressing and
releasing the Select or or . To seek
higher frequency station press . Press for
lower frequencies. Tuning begins at the current fre-
quency, seeks upward (or downward) and stops at the
next tuned station. Pushing or again con-
tinues the SEEK function. Once the highest frequency
is reached, the tuner continues SEEK mode at the
lowest frequency.
Frequency Scan
To scan, press and hold then release . The
tuner scans through tuned stations with a 5-second
preview before moving to the next station. To end
scanning, press again.
Selecting a Bank
To select a bank, press and hold for bank up
or for bank down.
Bank/Memory Presets
The AM/FM tuner has six banks of preset memory
settings, and each bank holds six presets for a total
of 36 possible presets.
Memory Preset Programming
1. Select a bank - press and hold or
until the desired bank # (1-6) appears on the keypad.
2. Select a station - tune to the desired frequency
with ,
,
or .
3. Press and hold a # button (1-6) until M(#) SA(ved)
is displayed.
Recalling a Memory Preset
Press and to scroll through a loop dis-
play of all the configured memory presets for the cur-
rently selected bank.
Mute
Press the button to mute/unmute the tuner
audio output.