Filter
Top Products
Operation
72 Runco LS-10d Installation/Operation Manual
PRE
L
IMINAR
Y
Front Panel Brightness: Select Front Panel Brightness from the Service menu to adjust
the brightness of the front-panel LED and LCD status indicators.
• Logo LED: Select Logo LED from the Front Panel Brightness menu to adjust the
brightness of the large, illuminated logo on the left side of the display. The range is from
0 (off) to 31.
• Standby LED: Select Standby LED from the Front Panel Brightness menu to change
the behavior of the front-panel STANDBY indicator LED. When set to ON, the LED
lights amber when the system is in standby mode; otherwise, it is off. When set to OFF,
the LED is always off.
•LCD: Select LCD from the Front Panel Brightness menu to adjust the brightness of the
front-panel LCD. The range is from 0 (off) to 4.
Auto Power Off: Select Auto Power Off from the Service menu to have the LS-10d turn
itself off after a period of inactivity (no source signal present).
•Enable: By default, Auto Power Off is disabled. To enable it, select Enable from the
Auto Power Off sub-menu and set it to On.
• Hours: The default time-out period is eight (8) hours; the range is from 1 to 24 hours.
System Reset: To reset ALL controller settings (including image settings) back to their
factory defaults, choose System Reset from the Service menu.
A confirmation message appears. Select Yes to continue with the reset or select No to
cancel.
This action is not undoable. Proceed with caution! Before you
perform a System Reset, save your “Custom” Memory Presets
(page 56) and ISF Day/Night Memory Presets (page 63).
Logo LED
LCD
Standby LED
Caution