Filter
Top Products
Installation
Runco LS-10d Installation/Operation Manual 29
PRE
L
IMINAR
Y
Adjusting the Projection
Angle
If the LS-10d is ceiling-mounted and the screen is significantly lower than the projector,
you can tilt the projector at a slight angle by adjusting the ceiling mount.
The projector can be rotated (side-to-side) up to 360 degrees and mounted without it
affecting performance. However, to ensure optimal performance of the lamp, limit the
front-to-back tilt of the projector to ±20 degrees; see Figure 3-6.
Figure 3-6. Mounting Angle Ranges (Front-to-Back and Side-to-Side)
If you do this, you may need to shift the image using the on-screen display (OSD) controls,
to compensate. For detailed instructions, refer to Primary Lens Adjustments on
page 40.
± 360º
± 20º