Filter
Top Products
13
Making the Connections
Refer to the figure shown below to connect the SA-300 and the other equipment.
fig.02-01
* To prevent malfunction and/or damage to speakers or other
devices, always turn down the volume, and turn off the power
on all devices before making any connections.
* Before making any connections, set the SA-300’s MASTER
VOLUME knob to “0.”
* Use only the specified expression pedal (EV-5, etc.; optional).
By connecting any other expression pedals, you risk causing
malfunction and/or damage to the unit.
* When connection cables with resistors are used, the volume
level of equipment connected to the inputs may be low. If this
happens, use connection cables that do not contain resistors,
such as those from the Roland PCS series.