Filter
Top Products
48
Playing in Patch Mode
Knob Part Select
Selects the part that will be controlled by the realtime control knobs.
Value:
KBD, PAD
Here’s how to specify the parameter that will be affected when you
operate a controller.
1.
Press [PATCH/RHYTHM] to access the Patch Play screen.
2.
Press [F4 (Ctrl Setting)].
fig.05-017_50
3.
Press [F1 (
⇑
)] or [F2 (
⇓
)] to select the parameter.
4.
Use [CURSOR] to move the cursor to the parameter.
5.
Either turn the VALUE dial or use [INC][DEC] to set the
value.
6.
If you want to keep the settings, press [F8 (System Write)].
When Patch mode is selected, controller settings cannot be
saved for each individual patch. Controller settings are saved as
system settings.
7.
When you have finished making settings, press [EXIT] to
return to the Patch Play screen.
D Beam (Pad Trigger)
Instead of striking the pads themselves, you can also use the D Beam
controller to control the sounding of the pads.
PAD trigger settings are saved independently for each
performance as part of the performance settings. This lets you
create performances that make effective use of controller
settings.
fig.05-018_50
For details on these settings, refer to
“Assigning a Parameter
to a Controller”
(p. 48).
Pad Number
Specifies the pad number affected by the D Beam.
When the cursor is located at this parameter, you can also make this
setting by striking the desired pad.
Value:
0–16
Pad Velocity
Specifies the strength of the pad sound played by the D Beam
controller.
Value:
1–127
Pad Control Mode
This specifies how the D Beam will behave when it is obstructed. If
this is set to MOMENTARY, the parameter will be on only while the
D Beam is obstructed, and will turn off when you stop obstructing it.
If this is set to LATCH, the parameter will alternately be switched
on/off each time you obstruct the D Beam.
Value:
MOMENTARY, LATCH
Assigning a Parameter to a
Controller
You can jump directly to various setting screens by holding
down the [SHIFT] and operating the following buttons or
knobs.
• Button at the right of the realtime control knobs
• Assignable switch
Fantom-X678_r_e.book 48 ページ ２００５年５月１２日 木曜日 午後４時４０分