Filter
Top Products
26
Overview of the Fantom-X
Broadly speaking, the Fantom-X consists of a controller section, a
sound generator section, and a sequencer section. These sections are
internally connected via MIDI.
fig.04-001.e
Controller Section
This section consists of the keyboard, pad, pitch bend/modulation
lever, panel knobs and buttons, and D Beam controller. It also
includes any pedals that may be connected to the rear panel. The
performance information generated when you do things such as
press/release a key or pad, or depress the hold pedal is converted
into MIDI messages and sent to the sound generator section,
sequencer section, and/or an external MIDI device.
Sound Generator Section
The sound generator section produces the sound. It receives MIDI
messages from the keyboard controller section and sequencer section
and/or from an external MIDI device, generates musical sound
according to the MIDI messages that were received, and outputs the
sound from the output jacks or headphone jack.
Sequencer Section
This section records operations of the keyboard controller section as
MIDI messages, and transmits the recorded MIDI messages to the
sound generator section. MIDI messages recorded on the sequencer
can also be transmitted from the MIDI OUT connector to allow the
Fantom-X to also control external MIDI devices.
The Sampler section
A sampler is a device that captures sounds from a CD player or mic
connected to the audio input or the digital input (or sounds from a
wave file) as “samples.”
Samples you record can be used in the same way as the waveforms
that are built into the internal sound generator. (p. 141)
The Fantom-X can load WAV or AIFF format wave files as samples
via a USB connection. Loaded sample can be used in patches or
rhythm sets.
When using the Fantom-X, you will notice that a variety of different
categories come into play when working with sounds. What follows
is a simple explanation of each sound category.
Tones
On the Fantom-X, the tones are the smallest unit of sound. However,
it is not possible to play a tone by itself. The patch is the unit of
sound which can be played, and the tones are the basic building
blocks which make up the patch.
fig.04-002.e
Tones consist of the following five components.
WG (Wave Generator)
Specifies the PCM waveform (wave) that is the basis of the sound,
and determines how the pitch of the sound will change.
The Fantom-X has 1,480 different waveforms. All patches built into
the Fantom-X consist of combinations of tones which are created
based on these waveforms.
There are four wave generators for each rhythm tone
(percussion instrument sounds).
TVF (Time Variant Filter)
Specifies how the frequency components of the sound will change.
TVA (Time Variant Amplifier)
Specifies the volume changes and the sound’s position in a stereo
soundfield.
Envelope
You use Envelope to initiate changes to occur to a sound over time.
There are separate envelopes for Pitch, TVF (filter), and TVA
(volume). For example if you wish to modify the way in which the
sound attacks or decays over time, you would adjust the TVA
envelope.
How the Fantom-X Is Organized
Basic Structure
Controller Section (controllers
such as keyboard, pad, pitch bend lever, etc.)
Sound
Generator
Section
Recording
Playback
Sequencer
Section
Play
Sampler
Section
Sampling
Resampling
Audio Input
Classification of Fantom-X Sound
Types
WG
Pitch
Envelope
TVF
TVF
Envelope
TVA
Envelope
TVA
LFO 1 LFO 2
control signal
Tone
audio signal
Fantom-X678_r_e.book 26 ページ ２００５年５月１２日 木曜日 午後４時４０分