Roland CUBE STREET Stereo Amplifier User Manual


 
8
Panel descriptions
18.
POWER Switch
This switches the power on and off.
* This unit is equipped with a protection circuit. A brief interval
(a few seconds) after power up is required before the unit will
operate normally.
* If you need to turn off the power completely, first turn off the
POWER switch, then unplug the power cord from the power
outlet. Refer to “Power Supply: Use of Batteries” (p. 4).
19.
AUX IN Jack
You can connect a CD player, MP3 player or other kind of
device and have it play along with your guitar or other kind
of devices. This accepts a stereo miniature phone plug.
* Determine the volume level by adjusting the volume control of
the connected device.
20.
STEREO PHONES Jack
Connect headphones to this jack.
* No sound is played through the unit’s
speaker while the STEREO PHONES
jack is in use.
If you use a PCS-31 connection cable,
you’ll also be able to use this as a stereo
recording output.
* If you're using a monaural cable, the
effect might be difficult to discern.
fig.01-01
21.
FOOT SW (Footswitch) Jack
A footswitch (BOSS FS-5U or FS-6; sold separately)
connected here can be used to switch on/off MUTE and
DELAY/REVERB for the MIC/LINE CH, and EFX and
DELAY/REVERB for the GUITAR/INST CH.
* If you use a monaural cable to connect just one footswitch,
you’ll only be able to control MUTE for the MIC/LINE CH,
and EFX for the GUITAR/INST CH.
22.
Security Slot ( )
http://www.kensington.com/
23.
AC Adaptor Jack
Connect the included AC adopter to this jack.
* Use only the AC adaptor included with the CUBE STREET.
24.
Grounding terminal
Depending on the circumstances of a particular setup,
you may experience a discomforting sensation, or
perceive that the surface feels gritty to the touch when
you touch this device, microphones connected to it, or
the metal portions of other objects, such as guitars. This
is due to an infinitesimal electrical charge, which is
absolutely harmless. However, if you are concerned
about this, connect the ground terminal with an external
ground. When the unit is grounded, a slight hum may
occur, depending on the particulars of your installation.
If you are unsure of the connection method, contact the
nearest Roland Service Center, or an authorized Roland
distributor, as listed on the “Information” page.
Unsuitable places for connection
Water pipes (may result in shock or electrocution)
Gas pipes (may result in fire or explosion)
Telephone-line ground or lightning rod (may be
dangerous in the event of lightning)
25.
Cord Hook
Hook the AC adaptor cord here (p. 9).
TIP:L
RING:R
white(L)
red(R)
PCS-31
22
21
25
23
24
white
EFX
DELAY/REVERB
red
PCS-31
Polarity Switch
white
MUTE
DELAY/REVERB
red
PCS-31
CUBE-Street_egfispd.book Page 8 Thursday, June 28, 2007 8:55 AM