Filter
Top Products
Information Cubed
The data acquired in the testing procedure is then graphed in the form
of a 3-dimensional cube. Hence the name PowerCube.
The
Phase Angle
is expressed on the horizontal axis, the
Output
Voltage
is presented on the vertical axis and the
Impedance
is
displayed on the Z axis.
Output Power,
in watts, is listed on the left
hand side for each impedance at each phase angle.
What is an Amplifier?
An amplifier by definition is a voltage generating device, recreating
the signal which is input to it identically but with increased volume.
It will be connected to a reactive load (the speaker). The impedance
of this load and phase of the signal passing through the load will vary,
dependent upon the frequency of the input signal (music).
Therefore, a perfect amplifier will be able to maintain the same output
voltage regardless of load characteristics and will not alter the signal
it is reproducing. A perfect amplifier when measured by the
AudioGraph PowerCube would present data that forms a perfect
cube. Unfortunately, amplifiers are not perfect. The laws of physics
generally prevent it. A great amplifier is about the best one can hope
to attain.
As you can see by the PowerCube and as you will experience by
listening, your Punch amplifier is a GREAT AMPLIFIER!
–60° (Cap)
0°
(Ind) +60°
1Ω
2Ω
4Ω
Impedance
8Ω
10V
30V
50V
8Ω –60°
–30°
0°
30°
60°
4Ω –60°
–30°
0°
30°
60°
2Ω –60°
–30°
0°
30°
60°
1Ω –60°
–30°
0°
30°
60°
84 W
84 W
83 W
84 W
85 W
159 W
154 W
153 W
154 W
158 W
266 W
251 W
245 W
248 W
261 W
378 W
343 W
333 W
339 W
373 W
AudioGraph – The PowerCube™
Amplifier:
Serial No:
Owner :
PUNCH 200ix 14.4V x 2
ROCKFORD CORPORATION
Rated Power : 100 W @ 4 Ohms
IMPEDANCE
MODEL BEING
TESTED
x2 = STEREO
MONO = BRIDGED MONO
VOLTAGE FROM
BATTERY
OUTPUT VOLTAGE
*
*
*
*
PHASE ANGLES
{
POWER
IN
WATTS
{
{
• Example of a 200ix PowerCube
– 30 –