Roberts Radio RDK-2 Radio User Manual


 
If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri)
6
Mains operation
1. Position your RDK2 touch panel radio as previously described.
2. Plug the mains plug into a wall socket and switch on the wall
socket.
• IMPORTANT: The mains plug is used as the means of connecting
the radio to the mains supply. The mains socket used
for the radio must remain accessible during normal use. In order
to disconnect the radio from the mains completely, the mains
plug should be removed from the mains socket outlet
completely.
8. Completely undo the thumb screws from the sides of the radio and
remove the mounting bracket.
9. Hold the mounting bracket against the pencil marks under the cupboard
and use the pencil to mark drill centres for the fi xing screws (4).
10. Your radio is supplied with screws of two lengths. Be sure to use screws
of appropriate length for the cupboard material. If those provided are
not suitable for your needs, please use screws with a similar diameter
and head design.
IMPORTANT: Before drilling holes and applying screws, please make
sure that the screws selected are not too long. Excessively long
screws may damage the interior of your cupboard.
11. Drill short pilot holes for the screws in the underside of the cupboard.
(Pilot hole diameter typically 2.5mm, suggested drill depth not more
than 12 - 14 mm)
12. Using the screws to fi t the mounting bracket to the cupboard taking
care not to over tighten them.
13. Offer the radio to the fi xed mounting bracket and re-insert the two
thumb screws.
14. Adjust the height of the radio beneath the cupboard as needed and
tighten the thumb screws. Tighten by hand only.
15. Secure the mains lead and aerial as needed. The aerial has a loop
formed at the free end. This can be fi xed as needed. Insert the mains
plug in the nearest convenient mains socket and secure the mains
lead so that it does not obstruct working in the kitchen.