Operating your radio - DAB
1. Place the wire antenna so that it is as straight as possible extending
either above or below the radio.
2. Plug the mains lead into a wall socket and switch on the wall
socket.
4. The radio will then display "Clock not Set...". The radio will scan for
DAB signals and if a DAB signal is found it will then show the current
time and date in the display.
5. If no signal is received the radio will continue to display "Clock not
Set". Try repositioning the antenna. Touch the On/Standby button and
the radio will re-scan. If a signal is found the radio will then tune to a
station and set the clock as soon as the time information is received.
If necessary reposition again and touch the Auto tune button to re-
scan until stations are found.
5
9