Filter
Top Products
Setting alarm time
Your radio has an alarm which can be set to wake you to DAB, FM radio or
beep type alarm. The alarm can be set to sound on Weekdays, Weekends,
Daily or Once. The alarm can be set when your radio is switched on
or in stand-by mode. In the event of a power interruption your radio has
a built in memory that will retain your alarm settings. The alarm feature
should only be used when the radio is powered from the mains.The radio's
clock does not operate when the radio is in standby and powered solely
from its batteries.
Note: If no buttons are pressed for 5 seconds, your radio will exit the
alarm setup.
1. Press the On/Off button to switch on the radio if required.
2. Press the Menu button once or twice as needed until "Main Menu"
appears on the display. Rotate the Tuning/Select control until "Utility"
shows on the display.
3. Press and release the Tuning/Select control to enter the Utility menu
and rotate until "Alarm" appears on the display. Press and release the
Tuning/Select control to enter alarm setup.
4. Rotate the Tuning/Select control to select On or OFF. If OFF is selected
any current setting for that alarm will be cancelled.
5. Choose the "On" setting then press and release the Tuning/Select
control the hour digits will fl ash on the display.
6. Rotate the Tuning/Select control to set the desired alarm hour.
7. Press and release the Tuning/Select control to enter the hour setting.
The minute digits will then fl ash on the display.
1
2
2-7
23