If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri)
14
Operating your radio - FM auto tune
1. Carefully extend the telescopic aerial fully and press the On/Off button
to switch on your radio.
2. Press and release the DAB/FM/AUX button to select the FM band.
3. Press and release the Auto Tune button to cause your radio to scan
in the direction previously scanned and stop automatically when it
fi nds a station of suffi cient strength.
4. After a few seconds the display will update. The display will show the
frequency of the signal found. If the signal is strong enough and there
is RDS data present then the radio will display the station name.
5. To fi nd additional stations press and release the Auto Tune button
as before.
6. To scan the FM band in a opposite direction either rotate the Tuning/
Select control clockwise or use Tuning Up button (to scan low frequency
to high frequency) or rotate anti-clockwise or useTuning Down button
(to scan high frequency to low frequency) and then press the Auto
Tune button again.
7. When the end of the waveband is reached your radio will recommence
tuning from the opposite end of the waveband.
8. Adjust the Volume and Tone controls to the required settings.
9. To switch off your radio press the On/Off button.
1,9
2
3,5,6
6
8
8 8
If you fi nd that an FM broadcast has a lot of background hiss, this may
often be reduced by setting the radio into Mono reception mode for the
current FM station. Please refer to the section "Stereo / Mono setting - FM"
on page 17 for further details.