Filter
Top Products
Rev.1.00 2003.05.08
page 9 of 23
M65881AFP
FsoCKO is clock output pin of 1fso frequency. The output is divided-clock of XfsoIN, and frequency
is free-running at power on. FsoCKO pin's clock is utilized for a synchronization in case that
have used plural M65881AFP, take a synchronization between M65881AFP and other external
devices.
Refer to the following Chapter 6. in detail.
6. FsoI, SFLAG
M65881AFP synchronizes in clock input from the external source devices. So it makes synchronized
operation between source devices or another M65881AFP ( in case of Multi channel Operation ).
The primary side operation ( input side of sampling rate converter ) are synchronized in LRCK, and the
secondary side operation ( output side of sampling rate converter ) are synchronized in FsoI.
M65881AFP detects rise edge of these synchronized clock in normal operation, and the M65881AFP
does operation of resynchronization in case that the cycle has changed.
In addition, the M65881AFP re-synchronizes for a synchronized clock, in case that M65881AFP detects
SYNC flag (Serial Control, System2 Mode,bit6) rise edge, too.
While re-synchronizing, SFLAG pin outputs "H" and data is muted inside.
In case of using Multiplex ( for multi channel application) and Single ( for 2ch application ), detail
explanation is shown below.
Multiplex use
Primary side: Synchronize with LRCK. All ICs synchronize with an source device by connecting
common LRCK.
Secondary side: Synchronize with FsoCKO of Master IC. One of M65881AFP becomes a master IC,
and the synchronization between ICs is carried out by FsoCKO of Master IC.
FsoCKO pin outputted from this master IC is entered each Fsol pins of master
and slave ICs.
Multiplex use (6ch)
Single use
Primary side: Synchronize with LRCK. Therefore M65881AFP synchronizes with source devices.
Secondary side: There is no need for external devices and other ICs to synchronize,
therefore FsoCKO is connected to FsoI, In other way,
By setting secondary side asynchronous detection to “disable” with
“ASYNCEN2” flag (Serial Control, System2 mode,bit8),
FsoI can also be considered as fixation.
LRCK (Primary side)
FsoCKO(Secondary side)
LRCK
LRCK
Fsol
Fsol
Master
Slave
Slave
LRCK
Fsol
ASYNCEN2=enable
LRCK (Primary)
LRCK
Fsol
ASYNCEN2=disable
LRCK (Primary)
LRCK
Fsol
ASYNCEN2=enable
FsoCKO
5. FsoCKO