Filter
Top Products
19
using the universal remote control
If you have questions about the use of the remote
buttons with another component, refer to the
component’s user’s guide.
MENU SELECT Programs the CD changer to play up
to 32 tracks in any order you choose.
Number Buttons Let you enter numbers when
needed.
PAUSE Pauses the CD.
PLAY Plays the CD.
RESET•REP Repeats a track, a CD or an entire
program. Press once to repeat the currently playing
track, twice for the CD or program, and three times to
turn the function off.
REV Moves backward through the CD one track at a
time.
STOP Stops the CD from playing.
Tape Deck Controls
FWD Fast forwards the tape.
Number Buttons Let you enter numbers when
needed.
PAUSE Pauses the tape.
PLAY Plays the tape.
POWER Turns the tape player off.
REV Rewinds the tape.
TAPE Turns on the tape player and puts the remote in
tape player mode.
LASERDISC PLAYER CONTROLS
CH + and CH – Changes to the next higher or lower
chapter on the laserdisc.
FWD Scans forward on the laserdisc.
LD•VCR2 For some laserdisc models, if programmed,
turns on the laserdisc player and puts the remote in
laserdisc mode.
Number Buttons Let you change to a specific
chapter.
PAUSE Pauses the laserdisc.
PLAY Plays the laserdisc.
PLAYLIST For some laserdisc models, if programmed,
programs to playback chapters on laserdisc in a certain
order.
POWER Turns the laserdisc player off.
REV Scans backward on the laserdisc.
STOP Stops the laserdisc.
Programming the
universal Remote
You can program the remote to control most brands of
remote controllable TVs, VCRs and cable boxes. If you
have an RCA, GE or ProScan VCR, you may not need to
program the remote at all. Other manufacturer’s
brands need to be programmed.
Programming the Remote
to Control a TV
To determine whether you need to program the
remote, turn on the TV, point the remote at the TV’s
remote sensor and press TV. Then, press the POWER, or
CH + or CH – button to see if the TV responds to the
remote commands. If not, you need to program the
remote.
Follow these steps to program your remote to control
your TV:
1. Turn on the TV.
2. Look up your TV brand and code number(s) in the
code list on the next page or on the code sheet
packed with your remote.
3. Press and hold the TV button on the remote.
4. Enter the three-digit code from the code list.
5. Release the TV button, then press POWER to see if
the TV responds to the remote commands. If not,
try pressing TV
then POWER.
6. Repeat steps 3 through 5 using the next code listed
for your TV brand until the TV responds to the
remote commands.