Filter
Top Products
Getting Started
EN
5
Digital Connections
If you have a SAT receiver DVD player or CD player with a
digital output, you can make use of an optical digital con-
necting cord (not supplied) or coaxial digital connecting
cord (not supplied) to carry the audio portion of the signal
and enjoy Dolby Digital or digital stereo sound quality. One
optical or coaxial cable is needed for each SAT receiver,
DVD player or CD player. When optical or coaxial cable is
used, the analog audio cables are still needed if recording
through a tape or VCR is desired. This receiver provides one
optical and one coaxial digital input for the connection of
your components. Please connect your components (e.g.
DVD, SAT or CD) to the appropriate digital inputs and
select the appropriate source (see below).
Read instructions carefully when connecting components to
the receiver.
Digital In Jacks can accept Dolby Digital (AC-3), or PCM sig-
nals when compatible components are connected.
Connecting the Antennas
The AM and FM antennas connect to the AM and FM ter-
minals on the system’s back panel.
They must be hooked up in order to receive clear reception.
AM Loop Antenna and FM Indoor Antenna
1. Uncoil the AM Antenna wire.
2. Press down on the Antenna tab to open the terminal
(Refer to the illustration on the bottom of page 6)
CENTER SUB
FRONT
REAR
LR
LR
L
IN OUT IN
R
SAT
IN
MON
OUT
VCR IN
VCR OUT
VCR SAT
110V 60Hz
1
This device complies with part 15 of the FCC rules. Operaton is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) This device must accept any
interference received, including interference that may cause
undesired operations
Manufactured under licence from Dolby Laboratories.
"Dolby", "Pro Logic 2" and the double-D symbol are
trademarks of Dolby Laboratories. Confidential
Unpublished Works. ' 1992-1997 Dolby Laboratories,
Inc. All rights reserved.
AUDIO VIDEO RECEIVER
POWER SOURCE: 120V 60Hz
POWER CONUMPTION: 300W
REFER INQUIRIES TO:
THOMSON MULTIMEDIA INC.
MANAGER CONSUMER RELATIONS,
P.O. BOX 1976, INDIANAPOLIS, IN46206
MADE IN CHINA
SPEAKERS
AM LOOP
FM 75‰
COAXIAL
IN
OPTICAL
IN
SAT
OPTICAL
OUT
SAT / DVD / CD Player
COAXIAL DIGITAL IN (AUDIO)
Connect to coaxial digital output
of DVD, CD, SAT or other
compatible devices.
OPTICAL DIGITAL IN (AUDIO)
Optical Fiber Cable
Connect to optical digital output of DVD, CD,
SAT or other compatible devices.
SAT / DVD / CD
COAXIAL
IN
OPTICAL
IN
SAT
OPTICAL
OUT
DIGITAL AUDIO
OPTICAL DIGITAL OUT
Connect to recording
device like CD, CDRW
player, DVD recorder,
mini disc etc.
SAT
SPEAKERS
AUDIO
DIGITAL AUDIO
VIDEO
HINT
• For FM reception, extend antenna to its full
length and arrange the Antenna at different parts
of the room until the reception is optimized.
• For AM reception, rotate the antenna
horizontally to get better reception.
AM LOOP
FM 75
Ω
White
GND
CENTER SUB
FRONT
REAR
LR
LR
L
IN OUT IN
R
SAT
IN
MON
OUT
VCR IN
VCR OUT
VCR SAT
COAXIAL
IN
OPTICAL
IN
SAT
OPTICAL
OUT
110V 60Hz
1
This device complies with part 15 of the FCC rules. Operaton is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) This device must accept any
interference received, including interference that may cause
undesired operations
Manufactured under licence from Dolby Laboratories.
"Dolby", "Pro Logic 2" and the double-D symbol are
trademarks of Dolby Laboratories. Confidential
Unpublished Works. ' 1992-1997 Dolby Laboratories,
Inc. All rights reserved.
AUDIO VIDEO RECEIVER
POWER SOURCE: 120V 60Hz
POWER CONUMPTION: 300W
REFER INQUIRIES TO:
THOMSON MULTIMEDIA INC.
MANAGER CONSUMER RELATIONS,
P.O. BOX 1976, INDIANAPOLIS, IN46206
MADE IN CHINA
AM LOOP
FM 75‰
SPEAKERS
AUDIO
DIGITAL AUDIO
VIDEO
NOTE
Optical and coaxial cables carry only the audio
portion of the signal. A video connection must also
be established by connecting a video cable to the
(SAT) video input.