Filter
Top Products
Getting Started
EN
9
Test Tone / Channel balance
Channel balance
Your receiver is equipped with a test signal generator for
balancing the channels. As the signal "travels" from chan-
nel to channel, adjust the level controls until each channel
plays at the same loudness level. (details see operation of
test/setup)
Level adjustment & surround channel level
expectation
Even though you adjust the surround channel to be as loud
as the others on the test signal, you'll find that on actual
program material the surround channel is usually much
lower than the front. Don't be tempted to readjust the sur-
round level; program producers use surround mostly for
subtle atmosphereics and ambience, and only rarely for
special effects. A good surround mix doesn't call attention
to itself; if it did, it would soon become distracting.
Connecting for Power
Make sure you connect all your other
electronic components and the
speakers before plugging your
receiver into the outlet. Plug the
power cord in the wall outlet,
matching the wide blade of the plug
with the wide slot in the outlet. Be
sure to insert the plug completely.
Using Headphones
To listen privately through your audio
system, use the PHONES jack on the
receiver. However, make sure you turn
down the volume before you put on
the headphones. Increase the volume
to the desired level after headphones
are in place.
Once headphones are connected, “HEADPHONE DOWNMIX
2 CHANNEL” will scroll on display. This feature automatical-
ly converts multi-channel outputs to 2 channel stereo for
your listening pleasure.
Hearing Comfort & Well-Being
• Do not play your headset at a high volume. Hearing
experts advise against continuous extended play.
• If you experience a ringing in your ears, reduce volume
or discontinue use.
Factory Setting
The RTDVD1 is preset to the following setting when you
first turn on the power
Source = DVD/CD
Volume setting = 45 dB
Bass & Treble = 0 dB
Restore to Factory Settings
You can always restore all settings back to its original state.
When the receiver is in STANDBY mode, press accordingly
on the main unit to restore all settings back to factory
default :
PRESET - PRESET + BASS/TREBLE
NOTE
The system is equipped with Dolby Digital, and
manufactured under License from Dolby
Laboratories.
Dolby Digital
Manufactured under
license from Dolby
Laboratories. “Dolby”,
“Pro Logic”, “Pro Logic II”
and the double-D symbol are trademarks of Dolby
Laboratories. Copyright 1992-1997 Dolby Laboratories,
Inc. All Rights Reserved.
NOTE
All preset radio stations and surround sound set-
ting will be lost after factory setting is restored.
Courtesy Dolby Laboratories