Filter
Top Products
29
Troubleshooting
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is
something wrong with this component, check the points below. Sometimes the trouble may
lie in another component. Investigate the other components and electrical appliances being
used. If the trouble cannot be resolved by following the suggested remedies below, take the
CD recorder to your nearest local RadioShack store.
This CD recorder has been manufactured to the specifications of RadioShack and is covered
by a limited warranty from RadioShack. If your CD recorder is not operating as it should, take
it to your local RadioShack store or call 1-800-THE-SHACK for assistance.
Problem Solution
No power. Check the connection to the AC power supply.
No sound from speakers. Check the connection to the stereo system.
No disc has been loaded. Load a disc.
The sound is noisy. The CD recorder is too close to a TV set or similar appliances.
Install the CD recorder away from TV’s and other electronic
devices or turn the devices off.
Remote control does not
work.
Check the batteries and replace them if necessary.
Use the remote control within the range of 15 ft./5m and point
at the front panel.
Clear obstacles between the remote control and the CD
recorder.
If a fluorescent light is near the CD recorder, turn it off.
Does not play. Load a disc with the label side up.
If the disc is dirty, clean the surface on the disc.
A blank disc has been loaded. Load a pre-recorded disc.
Sound skips. Place the CD recorder in a stable place to avoid vibration and
shock.
If the disc is dirty, clean the surface of the disc.
Do not use scratched, damaged, or warped discs.
The recording level is too
low.
Adjust the recording level.
Check the connected components. If the CD recorder still does
not operate normally, unplug the power cord from the outlet
and plug it in again.