Filter
Top Products
19
Programming a Sequence
of Tracks
You can program up to 32 selections from 2
discs to play in any order you choose.
Note: Shuffle playback does not work
during program playback.
1. Using your remote control, press
PROGRAM in the stop mode. STEP
01 appears and PROGRAM and the
track number
1 flashes.
2. Press
CD or CD-R to select the tray, and
press numeric buttons, or
F
or
J
to
select a track. If you make a mistake,
press the numeric buttons again.
3. Press
PROGRAM to store the track into
memory. The next program number
STEP 02 appears.
4. Repeat Steps 2 and 3 to program more
tracks, up to 32 selections. When you
select tracks from the same disc
successively, you do not have to press
CD or CD-R.
Notes:
• If you enter a track number higher than
the highest track on a CD, the CD
recorder ignores the entry.
• If you try to store more than 32
selections, the CD recorder displays
PGM FULL.
• If you press
PROGRAM without
selecting a track number, the CD
recorder programs the first track.
• To cancel the program mode, press
D
and
CLEAR.
5. When you finish the selection of track
numbers, press
D
. The track number
programmed to
ST: 01 appears.
6. Press
g
to play the sequence. After the
CD recorder plays all programmed
tracks, it stops and
ST: 01 appears.
The CD recorder keeps the sequence in
memory even after programmed
playback has finished or stopped by
pressing
D
.
Notes:
• During program playback, press
B
once to return to the beginning of the
current track. To return to the
beginning of the previous track in the
program, press
B
twice. To playback
the next track in the program, press
C
.
• If a program is stored, both
g
for the
PLAYBACK tray and
g
/
ENTER for the
RECORD/PLAYBACK tray work to play
the programmed tracks.
Checking/Changing the
Programmed Sequence
In the stop mode, press PROGRAM CHECK.
The CD recorder displays the programmed
sequence's first selection. Each time you
press
PROGRAM CHECK, the CD recorder
displays the next programmed selection.
To change a selection, repeatedly press
PROGRAM CHECK in the stop mode until
the CD recorder displays the track number
you want to change. Enter the desired track
number, then press
PROGRAM.