Filter
Top Products
12
An accessory may be mounted with the amplifier either in or out
of the rack, even if the amp is installed with rear rack ears.
MOUNTING- All Models
Mounting the Accessories
1. Turn off the amplifier before installing the accessory.
2. Make sure the SIP resistor networks are installed properly and no SIP sockets
are empty.
3. Line up the HD-15 connector on the accessory with the amplifier’s DataPort, then
press the accessory onto the back of the amplifier so that the HD-15 connector
inserts into the DataPort.
4. Use the three screws supplied to secure the accessory to the amplifier
chassis, as shown below. Two long screws go into the holes near the
DataPort, while the short screw goes through the hole in the tab on the right
edge of the accessory. Do not overtighten the screws.
5. Attach the input and output cables to the appropriate connectors on the
accessory. Use the amplifier’s normal output connectors for attaching speaker
and monitor cabling.