Plantronics CT14 Headphones User Manual


 
4 5
en
1 Remove the belt clip
by pulling one side of the belt clip to release the tab from the hole.
2 Squeeze the latch on the battery compartment cover and lift the cover.
3 Connect the Battery Pack connector.
Do not force. Plastic connectors will fit in only one way.
4 Insert battery pack into the battery compartment.
5 Insert tabs of cover into slots and push down to securely close
the cover.
Installing the Dial Pad Battery Wearing the Dial Pad with the Belt Clip
Black
Red
White
1 Plug the headset cord into the 2.5mm jack on the top of the dial pad.
2 Route the cord through the dial pad’s cable routing slot on the back of
the dial pad.
Attach the belt clip only after you have routed the cord.
3 Insert the tabs on the sides of the belt clip into the holes on either side
of the dial pad.
Press the belt clip down until it clicks into place.
To remove the belt clip pull one side of the belt clip to release the tab
from the hole.
Cable route