Filter
Top Products
Using the Tuner
59
En
BASIC
Naming Memorized Stations
You can input a name of up to four characters for each preset station in the receiver’s memory (see the previous
page). This name can be anything you choose. For example, you could input JAZZ for that station and when you
listen to it the name, rather than the frequency number, will appear on your display.
1 Press the TUNER button on the
remote control.
2 Press CLASS repeatedly to select the
class.
Repeatedly pressing this button cycles through the three
available classes, A, B and C.
3 Press ST + or ST – to select the preset
channel.
4 Press TUNER EDIT to select the station
name mode.
5 Enter the station name you want.
Names can be up to four characters long.
• Use the MULTI JOG dial (front panel) or the ST +/– but-
tons (remote) to select characters.
• Press ENTER to confirm a character. If no character is
input, a space is input.
To erase a station name, simply repeat steps 1-4 and input
four spaces instead of a name.
The possible selections are shown below.
6 Press ENTER when you have got the
characters you want to enter.
Repeat steps 2 to 5 to memorize up to 30 preset broadcast
station names.
1,5
5,6
23,5
4
European model
multi-voltage model
1,5
5,6
23,5
4
ABCDEFGHIJKLMNOPQRSTUVWXYZ
abcdefghijklmnopqrstuvwxyz
0123456789
!”#$%&’()*+,–./:;<=>?@[ \ ]ˆ_{|} [space]
Memo:
To change a station name, enter a new name over
the top of the existing one.
00_VSX-AX3.book Page 59 Monday, May 19, 2003 1:05 PM