Filter
Top Products
Controlling other equipment
08
59
En
Direct function
• Default setting:
On
(all components)
You can use the direct function feature to control one
component using the remote control while at the same
time, using your receiver to playback a different compo-
nent. This could let you, for example, use the remote
control to set up and listen to a CD on the receiver and
then use the remote control to rewind a tape in your VCR
while you continue to listen to your CD player.
When direct function is on, any component you select
(using the
MULTI CONTROL
buttons) will be selected by
both the receiver and the remote control. When you turn
direct function off, you can operate the remote control
without affecting the receiver.
1 Press and hold REMOTE SETUP for three seconds.
The
REMOTE SETUP
menu appears on the remote
control display.
2 Use
/
(cursor up/down) to select ‘DirctFnc’
from the menu and press ENTER.
Select Function
flashes in the display.
3 Press the MULTI CONTROL button for the compo-
nent you want to set.
The remote displays the component you want to set.
4 Use
/
(cursor up/down) to switch direct func-
tion on or off then press ENTER.
The display shows
COMPLETE
to confirm the setting.
5 Repeat steps 2–4 for as many components as you
want.
Note
• You can’t use direct function with the
TUNER
or
TV
CONT
functions.
Multi Operation and System Off
The Multi Operation feature allows you to program a
series of commands for the components in your system.
For example, you could turn on your TV, turn on your DVD
player and start playing the loaded DVD using only two
buttons on the remote control.
Similar to multi operations, System Off allows you to use
one button to stop and switch off a series of components
in your system at the same time.
Note
• Before Multi Operation and System Off will work
correctly, you must setup the remote to work with
your TV and other components (see
Recalling preset
codes
on page 54 and
Programming signals from
other remote controls
on page 55 for more on this).
• Power on and off commands only work with
components that have a standby mode.
Programming a multi-operation or a
shutdown sequence
1 Press and hold REMOTE SETUP for three seconds.
The
REMOTE SETUP
menu appears on the remote
control display.
2 Use
/
(cursor up/down) to select ‘MultiOpe’ or
‘SysOff’ from the menu and press ENTER.
If you selected Multi Operation
(
MultiOpe
),
Select
Function
flashes in the display.
If you selected System Off
(
SysOff
),
System Off
appears
in the display. Go to step 4.
3 Press the MULTI CONTROL button for the
component you want to start the multi-operation.
Multi Ope
appears in the display.
DVD/LD
VCR2 VIDEO CD
TV/SAT
MULTI CONTROL
VCR1 /
DVR
CD-R/
TAPE1
MD/
TAPE2
REMOTE
SETUP
ENTER
DVD/LD
VCR2 VIDEO CD
TV/SAT
MULTI CONTROL
VCR1 /
DVR
CD-R/
TAPE1
MD/
TAPE2
TUNER
TV CONT
REMOTE
SETUP
ENTER
VSX-9300.book 59 ページ ２００４年５月２１日 金曜日 午前１１時２８分