Filter
Top Products
Connecting your equipment
03
18
En
Connecting your TV
This page shows you how to connect your TV to the
receiver. To be able to play the sound from the TV’s built-
in tuner, connect the analog audio outputs from your TV
to this receiver.
If your TV has a built-in digital decoder, you can connect
the digital audio output to this receiver to enjoy Dolby
Digital and DTS sound from digital TV broadcasts.
1 Connect the MONITOR OUT video jack on this
receiver to a video input on your TV.
Make sure you don’t connect to the
MONITOR OUT
connection for
MULTI ROOM & SOURCE
.
• You can use a standard RCA video cable to connect
to the composite video jack, or for higher quality
video, you can use an S-video cable to connect to the
S-video jack (
S-VIDEO
).
• See
Using the component video jacks
on page 24 if
you want to use the component video outputs to
connect this receiver to your TV.
• See
About the video converter
on page 16 if you plan
on connecting your other video components using
different types of video cables than for your TV.
2 Connect the analog audio outputs from your TV
to the TV/SAT inputs on this receiver.
• Use a stereo RCA phono cable for the connection.
3 Connect an optical digital audio output from
your TV to the DIGITAL 1 (TV/SAT) input on this
receiver.
• Use an optical cable for the connection.
• If your TV only has a coaxial digital output, you can
connect it to one of the coaxial inputs on this receiver
using a coaxial digital audio cable. When you set up
the receiver you’ll need to tell the receiver which
input you connected the TV to (see
Assigning the
digital inputs
on page 75).
Note
• If your TV doesn’t have a digital audio output, omit
step
3
above.
AC IN
SWITCHED 100W(0.8A)MAX
SELECTABLE
CENTER
TV
VIDEO
IN
S-VIDEO
IN
ANALOG AUDIO OUT
LR
VSX-9300TX
DIGITAL AUDIO OUT
OPTICAL
COAXIAL
1
3
2
VSX-9300.book 18 ページ ２００４年５月２１日 金曜日 午前１１時２８分