Filter
Top Products
33
En
Operation
Displays & Controls
6 SOURCE button
Use to turn on/off other components connected
to the receiver.
7 The following buttons are both
controls for other components (like a
DVD player) and dedicated tuner
controls. The tuner controls are
explained here. You can use them after
you have pushed the TUNER MULTI
CONTROL button.
CLASS button (see pages 44, 46)
Use to switch between the three banks (classes)
of station memories.
MPX button (see page 42)
Use to switch between auto stereo and mono
reception of FM broadcasts. If the signal is weak
then switching to MONO will improve the sound
quality. Also, this is the pause button for CDs,
tapes, DVDs, etc.
BAND button (see pages 42, 43)
Use to switch between the AM and FM band
when in TUNER mode.
D. ACCESS button (see page 43)
Use to directly access a radio station by pressing
the number of the station you want.
8 LOUDNESS button
Use to switch on the loudness. This feature is
useful for getting good bass and treble sounds
listening at low volumes.
9 FUNCTION button
Use to select the playback or recording source.
This button lets you cycle through the different
functions of the receiver in the following order:
CD, tuner (FM/AM), AUX, CDR/TAPE/MD, VCR/
DVR, DVD/LD, DVD 5.1 CH., and TV/SAT.
0 RECEIVER button
This switches the receiver between STANDBY
mode and power ON.
- FL DIMMER button
Use this button to make the fluorescent display
(FL) dimmer or brighter. There are three
brightness settings as well as an off setting.
= LED display (see pages 23, 25)
This display flashes when a command is sent
from the remote control to the receiver. It also
flashes at other times, for example when
teaching the receiver preset codes.
~ EFFECT +/– buttons (see page 39)
Use to adjust the amount of effect in different
DSP sound modes or advanced listening modes.
! 2 3 5∞ ( FQ +/–, ST +/–) & ENTER
buttons (see pages 15 – 20, 42)
Use these arrow buttons when setting up your
surround sound system (see pages 15 – 20).
These buttons are also used to control DVD
menus/options and for deck 1 of a double
cassette deck player. The FQ +/– buttons can be
used to find radio frequencies. The ST +/–
buttons can be used to select the stations of
memorized radio frequencies.
@ TOP MENU button
In DVD mode this button brings you to the top or
most fundamental menu.
# CHANNEL +/– buttons
(4/DISPLAY, ¢/RF ATT)
Use to select the stations of memorized radio
frequencies. Also use to skip tracks backward or
forward on CDs, DVDs, etc. Also use to display
the RDS information (DISPLAY) and use to lower
the input level of a radio signal (RF ATT).
$ MUTING button
Use to mute the sound or restore the sound if it
has been muted.
% MASTER VOLUME +/– buttons
Use to set the overall listening volume.
^ REMOTE SETUP button (see page 23)
Use this button when setting up the remote
control to control other components.