Filter
Top Products
45
En
English
2
LED
1 While pressing the ENTER button press the
Input/Control Mode Select button you want
to preset. For the TV CONTROL buttons
press the TV CONTROL (Power) button
while pressing the ENTER button.
The LED lights.
To cancel the preset mode at any time
Press ENTER.
The remote control will also return to the previous
mode after thirty seconds of inactivity.
2 Use the number buttons to enter the 3 digit
setup code (see pages 49 for “Preset Code
List”).
The LED turns off.
After a code has been input the power of the compo-
nent being input will turn on or off.
The remote will return to the previous mode after
thirty seconds of inactivity.
The power of the component being input will only
turn on or off if that component is able to be turned
on directly by remote control.
3 Repeat process to assign preset codes for as
many components as you want.
• You can only input a code for the component type
written on each Input/Control Mode Select button.
• Even if you don’t input a preset code for the TV (TV/
SAT Input/Control Mode Select button) you will be
able to control your TV using the dedicated TV
CONTROL on the remote.
CAUTION:
• You may not be able to use a particular code even if it
is listed on pages 49.
• The remote control buttons will not be able operate
other equipment unless preset with the method
above.
1
Controlling the Rest of Your System
1
Recalling Preset Codes
The following steps show you how to recall preset codes
for each Input/Control Mode Select button or the TV
CONTROL buttons. In the former case, once the preset
code is assigned, pressing the button will automatically
set the remote to operate the respective component.
• Refer to “Preset Code List” on pages 49 for the
components and manufacturers available. You should
have no problem controlling a component if you find
the manufacturer in this list, but you can only set
these codes for the button that is assigned to that
component. So, for example, the TV codes can only
be set to the TV/SAT button.
Please note that there are cases where only certain
functions may be controllable after assigning the
proper preset code, or the codes for the manufacturer
in the list will not work for the model that you are
using.
• Refer to “Controlling the Rest of Your System” on
pages 47 & 48 for detailed explanations on how to
operate your other components.
1
TV CONTROL
(power)
SOURCE
RECEIVER
SLEEP
AUTO
SURROUND
SIGNAL SELECT
ADVANCED
SOUND
MODE
DIMMER
SETUP
DTV ON /OFF
CLASS MPX
TV CONTROL
D.ACCESS
DTV INFOCH RETURN
ENTER
TEST TONE
TOP MENU
DTV MENU
MENU
AUDIO
SUBTITLE
CHANNEL CHANNEL VOLUME
INPUT
SELECT
10
GUIDE
T.EDIT
DISPLAY
CH_SELECT
ROOM
SETUP
RECEIVER
MUTE
ST
TUNE
MASTER
VOLUME
ST
TUNE
DVD
ENTER
ENTER
DVR/ VCR
TV/SAT
FM/AM
FRONT