Filter
Top Products
34
En
Setting the Volume Level of
Each Channel (adjusting the
speaker volume balance)
Use to set the relative volume of each channel as you
find necessary.
1 Press RECEIVER to turn the power on.
2 Press MASTER VOLUME + or
––
––
– to adjust the
volume to an appropriate level.
3 Press TEST TONE to output the test tone.
The test tone is output in the following order.
Surround L
(LS)
Surround R
(RS)
Front L
(L)
Center
(C)
Front R
(R)
Subwoofer
(SW)
The test tone sequence corresponds to the speaker
settings.
4 Use the + or
––
––
– buttons to adjust speaker
levels so that you hear the test tone at the
same volume from each speaker when seated
in your main listening position.
• If a speaker is deselected in the center, surround
speaker or subwoofer setting mode (see page 30) then
no test tone will be output for that speaker.
• The channel level range is ± 10 dB.
• Levels can be set for each surround mode.
5 Press TEST TONE to turn off the test tone.
• Since the subwoofer transmits an ultra-low frequency
its sound may seem quieter than it actually is. Be
careful not to turn up your subwoofer too much and
check the volume with an actual source.
• The subwoofer volume is best controlled with the
volume control on the powered subwoofer.
• The speaker volume can be adjusted without
outputting the test tone by pressing CH SELECT and
+/− button.
• The default setting is 0 dB for all channels.
• If you have adjusted the channel level using the +
button, even if the master volume is all the way up
you’ll never actually get a volume level that is 0 dB
(full volume).
Fine Tuning Your Surround Sound
2
4
3,5
1
CH SELECT
button
(+/− button)
SOURCE
RECEIVER
SLEEP
AUTO
SURROUND
SIGNAL SELECT
ADVANCED
SOUND
MODE
DIMMER
SETUP
DTV ON /OFF
CLASS MPX
TV CONTROL
D.ACCESS
DTV INFOCH RETURN
ENTER
TEST TONE
TOP MENU
DTV MENU
MENU
AUDIO
SUBTITLE
CHANNEL CHANNEL VOLUME
INPUT
SELECT
10
GUIDE
T.EDIT
DISPLAY
CH_SELECT
ROOM
SETUP
RECEIVER
MUTE
ST
TUNE
MASTER
VOLUME
ST
TUNE
DVD
ENTER
ENTER
DVR/ VCR
TV/SAT
FM/AM
FRONT