Filter
Top Products
38
En
07
Using the Tuner
Finding a Station
The following steps show you how to tune in to FM and
AM radio broadcasts using the automatic (search) and
manual (step) tuning functions. If you already know the
exact frequency of the station you want to listen to, see
“Tuning Directly to a Station” on page 39. Once you are
tuned to a station you can memorize the frequency for
recall later—see “Memorizing Stations” on page 39 for
more on how to do this.
1 Press the FM/AM button on the remote
control to put it in tuner mode.
2 Press the FM/AM button again to change the
band (FM or AM), if necessary.
Each press switches the band between FM and AM.
3 Tune to a station using the TUNE + or TUNE
––
––
–
buttons.
Automatic tuning
To search for stations in the currently selected band,
press and hold either the TUNE + or TUNE –
buttons for about a second. The receiver will start
searching for the next station, stopping when it has
found one. Repeat this step to search for other
stations.
Manual tuning
To change the frequency one step at a time, press the
TUNE + or TUNE – buttons.
High speed tuning
Press and hold the TUNE + or TUNE − buttons for
high speed tuning, releasing the button once the
desired frequency is reached.
MPX mode
If there is interference or noise during a FM radio
broadcast, or the radio reception is weak, press the MPX
button to switch the receiver into mono reception mode.
This should improve the sound quality and allow you to
enjoy the broadcast.
1,2
MPX
3
SOURCE
RECEIVER
SLEEP
AUTO
SURROUND
SIGNAL SELECT
ADVANCED
SOUND
MODE
DIMMER
SETUP
DTV ON /OFF
CLASS MPX
TV CONTROL
D.ACCESS
DTV INFOCH RETURN
ENTER
TEST TONE
TOP MENU
DTV MENU
MENU
AUDIO
SUBTITLE
CHANNEL CHANNEL VOLUME
INPUT
SELECT
10
GUIDE
T.EDIT
DISPLAY
CH_SELECT
ROOM
SETUP
RECEIVER
MUTE
ST
TUNE
MASTER
VOLUME
ST
TUNE
DVD
ENTER
ENTER
DVR/ VCR
TV/SAT
FM/AM
FRONT
Channel Step Setting (multi-
voltage model only)
The unit has been factory preset to the channel allocation
value for the area in which it is to be sold. If this value is
set incorrectly, the tunes in frequency may be wrong, or
sound may be distorted, resulting in an inability to
reproduce reception signals at their proper sound quality.
For this reason, be sure to confirm that the values are set
correctly before first using the unit.
FM 100 kHz, AM 10 kHz:
Set to this position for areas with an FM reception step of
100 kHz and AM 10 kHz.
FM 50 kHz, AM 9 kHz:
Set to this position, for areas with an FM reception step
of 50 kHz and AM 9 kHz.
When unsure about the channel allocation for your area,
consult your dealer for correct information.
To Change Channel Steps (multi-
voltage model only)
With the power turned on, press the FM/AM button and
the DVR/VCR button on front panel at the same time for
five seconds to change the kHz setting.
• Each time the above operation is performed, the
channel tuning step will alternate between 10K STEP,
and 9K STEP.