Filter
Top Products
6
<ARB7181>
Loading the batteries
Introductory Information
“AA” IEC LR6 batteries x 2FM wire antenna AM loop antenna Remote control unit
Checking the Supplied Accessories
Please check that you have received all of the following accessories with the receiver.
The following marks and symbols are used throughout
this manual:
Provides additional information, precautions,
and advice.
Indicates a blinking button, indicator, or
display.
Indicates a steadily lit button, indicator, or
display.
How to Use This Manual
When you notice a decrease in the operating range of
the remote control, replace all batteries with new ones.
AA dry cell batteries ((“AA” IEC LR6)×2)
\
CAUTION!
Incorrect use of batteries may result in such hazards
as leakage and bursting. Observe the following
precautions.
• Never use new and old batteries together.
• Insert the plus and minus sides of the batteries
properly according to the marks in the battery case.
• Batteries with the same shape may have different
voltages. Do not use different batteries together.
Preparing the Remote Control
This manual is divided into two main sections :
SET UP
This section explains how to make the necessary
connections from the receiver to your other audio and
video components. Receiver operations described later
in this section under the heading “Preparations” enable
you to set up and customize your home entertainment
center.
OPERATION
This section provides complete information about
operation of the receiver and supplied remote control.
memo
When changing the batteries, it is
recommended that you load new batteries
within five minutes of removing the old
batteries. If not, the preset codes may be
canceled and you will need to set them again.
Power connection
[SWITCHED 100 W (0.8 A) MAX]
Switching this receiver on or putting it in standby also switches components connected to the receiver’s AC OUTLET
jacks on and off. When connecting components to the AC OUTLET jacks, leave the power switch of the connected
components in the ON position. Total power consumption of connected components should not exceed 100W (0.8 A) .
CAUTION!
• To avoid malfunction, overheating, and possible fire risk, do not connect high-wattage appliances such as blow
dryers and irons to the AC OUTLET jacks.
• Do not connect a monitor or TV set.
Even if the power consumption of the TV or monitor is within the acceptable limits, when monitors or TV sets are
switched on, they consume a large amount of power and may exceed the capacity of this receiver.
memo
9
(
(
9