Filter
Top Products
30
<ARB7181>
Playing Sources with Dolby Digital or DTS Sound
Sound Modes
1
Follow steps 1 to 3 of the playback procedure. (Refer to
“Playback” on page 40.)
1 Turn on the power of the playback component.
2 Press RECEIVER to turn on the receiver.
3 Press FUNCTION to select the source component you want to play.
2
Press SIG.SELECT on the remote control or SIGNAL
SELECT on the front panel to select DIGITAL.
(Refer to “Switching ANALOG/DIGITAL signal input” on the previous
page.)
3
Press to switch the Dolby/DTS mode on.
Each press changes the Dolby/DTS mode.
(Refer to “Switching the Dolby/DTS mode” on page 32.)
4
Start playback of the component you selected in step 1.
5
Press VOL (+/–) to adjust the volume level.
DVD/LD
VCR 1
TV/SAT
CD
TUNER
VCR 2
MD/TAPE
TV CONTROL
RECEIVER
DSP MODE
CH.SELECT
ATT SIG.SELECT
MIDNIGHT
TEST TONE
AUDIO/VIDEO PRE-PROGRAMMED
REMOTE CONTROL UNIT
2
3
5
0
6
9
+10
TV/VCRCLASS
7
8
4
1
CHANNEL
MULTI CONTROL
ENTER
VOL VOL
FQ
FQ
+
–
TV FUNC
RECEIVER
TV
MUTING
CN.LEVEL
EFFECT
FL DIMMER FUNCTION DIRECT
MODE CHECK
COMMANDER
SET UP
Î
MEMU
2
3
5
2
3
5
When playing LD recorded in Dolby Digital
When connecting a DVD/LD player or LD player using the AC-3 RF output, a commercially available RF demodulator
(RFD-1) is required. The RF demodulator changes the RF signal to a digital signal which is then processed by the
receiver at the digital input jacks. For more details, refer to the instruction manual supplied with the RFD-1.
Refer to pages 52, 53 for explanations of Dolby Digital, Dolby Pro Logic, and DTS.
memo
• When an LD or CD player compatible with DTS is played back with
SIGNAL SELECT set in “ANALOG”, digital noise is output caused by
playing back the DTS directly (no decoding). To prevent noise, you need to
make digital connections (Refer to pages 20, 21) and set SIGNAL SELECT
to “DIGITAL”.
memo