Filter
Top Products
43
<ARB7181>
SET UP
OPERATION
Other Operations
Recording from Video Components
The following operations show you how to record audio and video to the video tape recorder connected to the VCR 1 or
VCR 2 jacks.
1
Select the component you want to record.
Be sure to press SIG. SELECT on the remote or SIGNAL SELECT on the
front panel to choose “ANALOG”. (Refer to “Switching ANALOG/
DIGITAL signal input” on page 29.)
2
Prepare the program source.
(Load the DVD or LD, etc.)
3
Insert a blank tape into the video tape recorder (VCR 1).
4
Start recording on the video tape recorder, then start
playback from the source component.
1
1
DVD/LD
VCR 1
TV/SAT
CD
TUNER
VCR 2
MD/TAPE
TV CONTROL
RECEIVER
DSP MODE
CH.SELECT
ATT SIG.SELECT
MIDNIGHT
TEST TONE
AUDIO/VIDEO PRE-PROGRAMMED
REMOTE CONTROL UNIT
2
3
5
0
6
9
+10
TV/VCRCLASS
7
8
4
1
CHANNEL
MULTI CONTROL
ENTER
VOL VOL
FQ
FQ
+
–
TV FUNC
RECEIVER
TV
MUTING
CN.LEVEL
EFFECT
FL DIMMER FUNCTION DIRECT
MODE CHECK
COMMANDER
SET UP
Î
MEMU
SIG. SELECT
SIGNAL SELECT
memo
The receiver’s volume, balance, tone (BASS, TREBLE, and LOUDNESS), and surround effects have no effect
on the recorded signal.
memo
• Recording cannot be made from analog to digital, and similarly
from digital to analog.
• When recording a DVD, the recorded image may flicker or be
difficult to view because of the copy protection signal
programmed on the DVD.