Filter
Top Products
HANDLING DISCS AND OTHER MEDIA
25
En
English
To disconnect a USB storage device
1 Hold the STOP button pressed for one second or more.
2 Confirm that the indicator goes out.
Confirm on the front panel that the red indicator for the
connected port has change from flashing to off.
3 Disconnect the USB storage device.
CAUTION
Depending on the device used, proper playback may
not be possible with all USB storage devices. Pioneer
assumes no responsibility for any loss of data
resulting from connecting any given USB device to
this unit.
• Proper operation may not be possible when a USB storage
device is connected through a USB hub.
• Even if a USB hub is used to connect multiple USB storage
devices, the second and later devices cannot be used.
• This unit may not operate properly due to insufficient power
if it is connected to a bus-power type USB hub when
another connected USB device draws heavy power
consumption from the same hub.
• Even if the USB storage device is connected directly to this
unit, if excessive current is drawn by the device, power may
be shut off, resulting in failure of data transmission (an
error message will appear on the center display). Following
the instructions in “To disconnect a USB storage device” (P.
25), disconnect the device. If data transmission is still not
possible, try turning the power off and on again.
• Operation cannot be guaranteed when using a USB
storage device with installed flash card reader.
• When connecting a USB storage device utilizing two USB
cables, connect both cables to this unit’s USB ports.
MEMO
• After the indicator goes out, if the STOP button is held
depressed for two seconds or more, the USB storage device's
connection can be reinitiated without the need to physically
disconnect and reconnect it.
CAUTION
When disconnecting a USB storage device, always be
sure to perform the STOP operation first.
If the STOP operation is not completed before
disconnection, cue/loop memory and playlist update
may not occur properly, resulting in the loss of data.
Also, the USB storage device may becomes
unreadable, or other substantial damage may occur.
In the case of a HDD device, do not subject it to
impact or vibration during use.
Always disconnect the USB storage device before
turning off the power to this unit.
MEP-7000_7L_EN.book 25 ページ ２００８年３月５日 水曜日 午後６時４分