Filter
Top Products
Additional information
10
45
En
English
FrançaisDeutsch
Nederlands
Italiano Español
Error Messages
No HDMI video output • Make sure that you’ve selected this player as the HDMI input in the settings for
the component you’re using (refer to the component’s instruction manual).
• Check that the HDMI cable is connected properly and isn’t damaged.
• Check that components connected using the HDMI interface are switched on
and HDMI compatible. (components must be compatible with both DVI and High
Bandwidth Digital Content Protection (HDCP).)
• This unit has been designed to be compliant with HDMI Version 1.1. Depending
on the component you have connected, using a DVI connection may result in
unreliable signal transfers.
• Make sure the resolution on this unit matches that of the component connected
using HDMI. See
Video Output settings
on page 27 to change the resolution.
• If the screen goes blank after changing the resolution, it means the you selected
a resolution incompatible with your monitor. See
Resetting the HDMI connection
on page 34 to reset to the factory defaults.
Color problems occur
with your monitor after
changing the
HDMI
Color
setting (page 27).
• Depending on the connected equipment, some
HDMI Color
settings may cause
the picture to be displayed incorrectly. In this case, use the TV's own video input
settings to select RGB, if possible. Alternatively, revert to the previous
HDMI Color
setting.
Problem
Remedy
Message Description
2CH ONLY
• An operation is prohibited because it is only applicable to 2 channel
sources, while the current source is a multichannel source.
96K
• An operation is prohibited because the source is 96 kHz digital.
SND. DEMO
• The sound demo is on. See
General
in
Troubleshooting
on page 42.
NOISY
• Background noise is too high to complete MCACC setup successfully.
ERR MIC
• An error occured during MCACC setup because the microphone is not
connected or is not connected properly.
ERR SP
• An error occured during MCACC setup because the speakers are not
connected or are not connected properly.
MUTING
• An operation is prohibited because the sound is muted (press
MUTE
).
STEREO
• An operation is prohibited because the tuner is selected.
TRAYLOCK
• The tray lock is on. See
General
in
Troubleshooting
on page 42.
KEY LOCK
• The key lock is enabled. See
Key lock setting
on page 37.
PHONESIN
• An operation is prohibited because the headphones are connected.
USB ERR
• See
Important
in
Using the USB interface
on page 23 for more on this.
HDMI ERR
• See
HDMI connection
above for troubleshooting tips. See also
Resetting the
HDMI connection
on page 34 if the problem persists.
EEP ERR
• Contact your Pioneer authorized service center or your dealer for servicing.
XV-DV656.book 45 ページ ２００６年４月７日 金曜日 午後６時４０分