Pioneer HTZ656DVD Home Theater System User Manual


 
Surround sound settings
06
25
En
English
FrançaisDeutsch
Nederlands
Italiano Español
Chapter 6
Surround sound settings
Using the Setup menu
From the Setup menu you can access all the
surround sound settings of the system
1
,
including channel levels, speaker distances
and dynamic range adjustment. The Auto
MCACC feature (page 9) should give you the
best surround sound setup. However you may
find that by further adjustment of the surround
sound settings you can improve the surround
sound in your listening room.
1 Press
SHIFT+SETUP
and use
/
then
ENTER
to choose the setting you want to
adjust.
The available settings are shown in the front
panel display.
2
2 Use
/
to adjust then press
ENTER
to
confirm and exit.
Note that using the Auto MCACC (page 9)
again overwrites the speaker settings.
Channel level setting
Set the relative channel levels from your main
listening position.
3
Use
/
to switch between channels in the
following order:
L
– Front left speaker
C
– Center speaker
R
– Front right speaker
SR
– Surround right speaker
SL
– Surround left speaker
SW
– Subwoofer
The channel level range is ± 10 dB.
Speaker distance setting
Specifies the distance from your listening
position to your speakers.
When
DISTANCE
appears, press
ENTER
, then
use
/
to adjust the distance, and
/
to
switch between the following speakers:
L
– Front left speaker
C
– Center speaker
R
– Front right speaker
SR
– Surround right speaker
SL
– Surround left speaker
SW
– Subwoofer
Each speaker can be adjusted between
0.3 m
and
9.0 m
. The default setting is
3.0 m
.
Dynamic Range Control
Specifies dynamic range adjustment to Dolby
Digital or some DTS soundtracks. If low level
sound or dialog seem difficult to hear properly,
this can help by bringing up the low level
sounds, while controlling high level peaks.
DRC OFF
(default)
– No dynamic range
adjustment (use when listening at higher
volumes)
DRC MID
– Mid setting
DRC HIGH
– Dynamic range is reduced
(loud sounds are reduced in volume while
quieter sounds are increased)
Note
1 There are other settings you can adjust from the Setup menu; these are explained in
Improving poor FM reception
on page 12
and
Dimming the display
on page 37.
2 The setup menu is exited automatically after 5 minutes of inactivity.
3• You can’t adjust center/surround when Stereo or Virtual playback is selected (or with stereo sources using the Auto mode).
• The Channel level setting is not available when headphones are connected.
• The speaker volume can be adjusted at any time by pressing
SHIFT+TEST TONE
and then using
/
to adjust the channel
levels. The test tone automatically moves from speaker to speaker in the order listed above. You should hear the test tone at the
same volume from each speaker when seated in the main listening position. Press
ENTER
when you’re finished.
• Since the subwoofer produces ultra-low frequencies, it may seem quieter than it actually is.
XV-DV656.book 25 ページ 2006年4月7日 金曜日 午後6時40分