Filter
Top Products
Getting started02
10
En
• Press
SHIFT+MCACC
to cancel and revert
to the previous Auto MCACC settings.
• If the noise level is too high,
NOISY
blinks
in the display for five seconds. To exit and
check the noise levels
1
, press
SHIFT+MCACC
, or to try again, press
ENTER
when
RETRY
shows in the display.
• If you see an
ERR MIC
or
ERR SP
message
in the display, there may be a problem with
your mic or the speaker connections. To try
again, press
ENTER
when you see
RETRY
2
.
When the MCACC setup is complete, the
volume level returns to normal and
COMPLETE
3
shows in the display, indicating
that the MCACC setup is complete and
Acoustic Calibration EQ has been activated.
4
Using the on-screen displays
For ease of use, this system makes extensive
use of graphical on-screen displays (OSDs).
All the screens are navigated in basically the
same way, using
,
,
,
to change the
highlighted item and pressing
ENTER
to select
it.
5
Important
• Throughout this manual, ‘Select’ means
use the cursor buttons to highlight an item
on-screen, then press
ENTER
.
Tip
• The button guide at the bottom of every
OSD screen shows you which buttons
you’ll need to use for that screen.
Playing discs
The basic playback controls for playing DVD,
CD, Video CD/Super VCD, DivX video and
WMA/MP3/MPEG-4 AAC discs are covered
here.
Further functions are detailed in chapter 4.
1 If the player isn’t already on, switch it on.
If you’re playing a disc with video, also turn on
your TV and make sure that it is set to the
correct video input.
2 Press
OPEN/CLOSE
to load a disc.
Load a disc with the label side facing up, using
the disc tray guide to align the disc (if you’re
loading a double-sided DVD disc, load it with
the side you want to play face down).
Note
1• If the room environment is not optimal for the Auto MCACC setup (too much ambient noise, echo off the walls, obstacles
blocking the speakers from the microphone) the final settings may be incorrect. Check for household appliances (air condition-
er, fridge, fan, etc.), that may be affecting the environment and switch them off if necessary.
• Some older TVs may interfere with the operation of the mic. If this seems to be happening, switch off the TV during the Auto
MCACC setup.
2 If this doesn’t work, press
SHIFT+MCACC
, turn off the power, and check the problem indicated by the
ERR
message, then try
the Auto MCACC setup again.
3 If
COMPLETE
doesn’t appear, it is likely an error occurred during the setup. Please check all connections and try again.
4 See
Listening with Acoustic Calibration EQ
on page 15 to switch on/off Acoustic Calibration EQ.
5 The screen saver will appear after five minutes of inactivity.
Button What it does
HOME
MENU
Displays/exits the on-screen display
Changes the highlighted menu item
ENTER
Selects the highlighted menu item
RETURN
Returns to the main menu without
saving changes
Button
What it does
XV-DV656.book 10 ページ ２００６年４月７日 金曜日 午後６時４０分