Pioneer HTZ656DVD Home Theater System User Manual


 
Additional information10
36
En
Chapter 10
Additional information
Optional system settings
All the available settings in the standby setup
menu are listed below
1
. See the notes in each
section for more information about the
settings. The first setting in each section is the
default.
1 Switch the system into standby.
2 Press
SHIFT+SETUP
and use
/
then
ENTER
to choose the setting you want to
adjust.
The available settings are shown in the front
panel display.
2
3 Use
/
to adjust then press
ENTER
to
confirm and exit.
System demo setting
Switches the automatic demo feature on or off
(this starts when you plug in for the first time):
DEMO ON
– Switches the demo feature on.
DEMO OFF
– Switches the demo feature off.
Frequency step setting
If you find that you can’t tune into stations
successfully, the frequency step may not be
suitable for your country/region.
AM 9K
AM 10K
TV system setting
Not applicable to the Taiwanese model
The default setting of this system is
AUTO
, and
unless you notice that the picture is distorted
when playing some discs, you should leave it
set to
AUTO
. If you find picture distortion with
some discs, set the TV system to match your
country or region’s system. However, this may
restrict the kinds of disc you can watch. See
the table for the kinds of discs compatible with
each setting (
AUTO
,
PAL
and
NTSC
).
3
After using
/
to choose
TV SYS
(step
2
above), press
ENTER
to change the TV
system as follows:
AUTO
NTSC
NTSC
PAL
PAL
AUTO
The system automatically switches on and
you’ll see the new TV system setting in the
display after seeing
WELCOME
.
4
Note
1 The HDMI features are explained in
Connecting using HDMI
on page 34.
2 The setup menu is exited automatically after 5 minutes of inactivity.
3 Most models of the newly developed countdown PAL TV system detect 50 Hz (PAL)/60 Hz (NTSC) and automatically switch
vertical amplitude, resulting in a display without vertical shrinkage. However, in some cases, the image may appear without col-
or. If your PAL TV does not have a V-Hold control, you may not be able to watch NTSC discs because of picture roll. If the TV has
a V-Hold control, adjust it until the picture stops rolling. On some TVs, the picture may shrink vertically, leaving black bands at
the top and bottom of the screen.
Player setting
Media Type
Format NTSC PAL AUTO
DVD/Super VCD/
Video CD/DivX
Video
NTSC
NTSC PAL NTSC
PAL
NTSC PAL
PAL
CD/MP3/WMA/
MPEG-4 AAC/
JPEG/no disc
NTSC PAL
NTSC or
PAL
4 You have to switch the player into standby (press
STANDBY/ON
) before each change.
XV-DV656.book 36 ページ 2006年4月7日 金曜日 午後6時40分