Filter
Top Products
Other connections
09
33
En
English
FrançaisDeutsch
Nederlands
Italiano Español
Important
• With an SR+ cable connected, the remote
must now be pointed towards your plasma
display rather than the remote sensor of
this unit in order to control this system.
• Use a 3-ringed miniplug SR+ cable to
connect the
CONTROL IN
jack of this unit
through a media receiver to the
CONTROL
OUT
jack of your plasma display.
1
Before you can use the extra SR+ features, you
need to make a few settings in the unit. See
SR+ Setup for Pioneer plasma displays
below
for detailed instructions.
SR+ Setup for Pioneer plasma
displays
Make the following settings if you have
connected a Pioneer plasma display to this
unit using an SR+ cable. Note that the number
of video inputs available will depend on the
plasma display you’ve connected.
1 Press
SHIFT+SR+
on the remote.
2 Use the
/
to select SETUP, then
press ENTER.
3 Use
/
to select the setting you want.
•
VoL.C OFF
– This unit does not control the
volume of the plasma display.
•
VOL.C ON
– When this unit is switched to
one of the inputs that use the plasma
display (
DVD
, or another one of functions
below), the volume on the plasma display is
muted so only sound from this system is
heard.
4 Assign any input source connected to the
plasma display to the corresponding input
number.
Use
/
to select the source (
DVD
,
LN
(
LINE
) or
USB
), then
/
to select the input
number.
This matches this unit’s input source with a
numbered video input on the plasma display.
2
For example, select the
LN PDP3
setting if the
video output of your line component is
connected to video input 3 on the plasma
display.
TVTN
switches the plasma display to
its built-in tuner and
NONE
leaves the plasma
display input as is (no switching takes place).
5 When you're finished, press
ENTER
.
Switching on the SR+ mode
1
Press
SHIFT+SR+
on the remote.
2 Use
/
to select SR+ ON then press
ENTER.
To switch SR+ control off, select
SR+ OFF
.
• If you disconnect the SR+ cable or switch
the plasma display off while SR+ is on, the
SR+ ON
setting remains.
• The SR+ setting is maintained even after
switching this system into standby then
back on. Automatic muting will be effective
when this system is switched on.
Note
1 You won’t be able to use the remote sensor of this unit with the
CONTROL IN
jack of this unit connected to the
CONTROL
OUT
jack of your plasma display. You can use the remote sensor of the plasma display (even in standby) as long as the power
isn’t switched off.
2 The
PDP5
input may be called ‘PC Input’ (or similar) on your plasma display.
XV-DV656.book 33 ページ ２００６年４月７日 金曜日 午後６時４０分