Pioneer HTZ373DVD Home Theater System User Manual


 
Getting started02
14
En
Listening to the radio
The tuner can receive both FM and AM
broadcasts, and lets you memorize your
favorite stations so you don’t have to manually
tune in every time you want to listen.
1 Press
TUNER
to switch to the tuner, then
press repeatedly to select the AM or FM band.
The display shows the band and frequency.
2 Tune to a frequency.
There are three tuning modes — manual, auto,
and high-speed:
Manual tuning: Press TUNE +/–
repeatedly to change the displayed
frequency.
Auto tuning: Press and hold TUNE +/–
until the frequency display starts to move,
then release. The tuner will stop on the next
station it finds. Repeat to keep searching.
High-speed tuning: Press and hold
TUNE +/– until the frequency display starts
to move rapidly. Keep the button held down
until you reach the frequency you want. If
necessary, fine tune the frequency using
the manual tuning method.
Improving poor FM reception
If you’re listening to an FM station in stereo but
the reception is weak, you can improve the
sound quality by switching to mono.
1 Tune to an FM radio station then press
SHIFT+SETUP
.
2Use
/
to choose FM MODE then press
ENTER
.
3Use
/
to select
FM MONO
then press
ENTER
.
The mono indicator ( ) lights when the tuner
is in mono reception mode.
Select FM AUTO above to switch back to auto-
stereo mode (the stereo indicator ( ) lights
when receiving a stereo broadcast).
Memorizing stations
You can save up to 30 station presets so that
you always have easy access to your favorite
stations without having to tune in manually
each time.
1 Tune to an AM or FM radio station.
Select mono or auto-stereo reception (FM)
as necessary. These settings are saved along
with the preset.
2Press
SHIFT+SETUP
and use
/
to
choose ‘ST.MEM.’ then press
ENTER
.
3Use
/
to select the station preset you
want then press
ENTER
.
Listening to station presets
1 Make sure the
TUNER
function is
selected.
2Use the
ST +/–
buttons to select a station
preset.
You can also use the number buttons to do
this.
Listening to other sources
You can connect auxiliary sources (TV, satellite
receiver, etc.) to this unit for playback through
the speaker system. See Connecting auxiliary
components on page 33 for more on this.
To connect a USB device to the USB
terminal, see USB playback on page 25.
1 Make sure that the external source (TV,
satellite receiver, etc.) is switched on.
2Press
LINE
to select the source.
Each press switches between LINE
1
and LINE
2
.
3 If necessary, start playback of the source.
HTZ373_777_EN.book Page 14 Wednesday, March 5, 2008 1:08 PM